What's better than a single LED? Lots of LEDs! A fun way to make a small linear display is to use two 12-bar Bi-color bar-graphs. Wouldn't it be awesome if you could control a colorful bargraph without tons of wiring? That's where this LED bar-graph backpack comes in. Much like Adafruit's 8x8 and 7-segment backpacks, this backpack pairs perfectly with our bar-graphs and manages all the LED control and multiplexing. 

The backpack uses a driver chip that does all the heavy lifting for you: It has a built in clock so it can multiplex the display. It uses constant-current drivers for ultra-bright, consistent color, 1/16 step display dimming, all via a simple I2C interface. The backpack comes with address-selection jumpers so you can connect up to eight of these bar-graphs on a single I2C bus. You can also mix-and-match the bar-graph breakout with our other types of I2C LED backpacks. 

The product kit comes with:

• A fully tested and assembled LED backpack stick
• Two 12-bar bi-color bar-graphs
• 4-pin header

A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes. 

Of course, in classic Adafruit fashion, they . They even wrote . If you've been eyeing matrix displays but hesitated because of the complexity, this is the solution you've been looking for!